Alan

You can change the capacitors in the powersupply.I have done that on several with same problem.its a bit tricky,so you must be an electronic guy to do it,not to destroy the PCB.they sit very tight,so you have to find the same sizes. gruss alan Danemark

I think you can still get them for Victoria´s from cinemeccanica.BUT they are not cheap. gruss alan

if you are into electronic or know someone,then take the LT+RT from the back of the cp65,and sum them through a opamp,then you have left-center-right,and l+r still have the surr. info alan

The CP55,had a 03 format,where the surround were turned off.BUT it was just turned off.The CAT150 still decoded it.A few film in the start of DOLBY STEREO did not have surround information.therefore format 03. When the CP55 later was converted to have SR the buttom was changed to this. You can still in the CP65 make this format,on the matrix card,but it wil do the same.Just turn off the surroundchannel. alan

Hi PM me,I have something. alan.lyman(at)mail.dk gruss alan

you have to activate the takeup arm,before you can control the speed on the takeout disc with the unit. Alan

there has been MANY different electric setups,inside a V5.you must start to oplaod a picture from inside.then maybe I can help alan

Hello again this how you get subwoofer as well. go into the user format you made press more press optical decoder config press bass extension lcr to subw,then press ok then you have subw in the eq config,you can choose cutt off freq,eq expander,and subw gain have fun alan

ok if you make your own userformat,where you just copy from existing format 60 or 61,then in the x-point,you can remove the x-for surrounds. I think you can also in the subw menu add the subw.I will have to chéck that on my own. alan

hello Holger do I understand correct,that you only want Left-Right and sub,out of the Nonsync input? gruss alan

I think I have the breakoutboards for this.Also I made my own,when connected to a DA20,because the DA20,will revert the CP65,when not running SRD.If you are interested alan

I might have some,shall I look?? gruss Alan Danmark

Hello Karel There are several different motor for this projector,both 3phase and single fase. do you have the toothed wheel for the motor?If yes count how many teeth if you email me,I can send you the manual alan

Hello jerry normally there are only two parameters you are alowedd to adjust. the angle and how much in that angle. alan

good to know alan

It could be when you shut it off,Its not uncommon to have card faults in the log,when shutting the cp off,because it sees it as a fault,when its just shutting down. alan

Maybe its because you send a "mute"command first.try to delete that. alan

hello you shoulld try to replace all the microswitches on the side.they are standard,and I have replaced many,because of many different faults.Maybe first check that it is aligned perfectly,so all switches is engaed when they should.I might have a pdf schematic of it. alan

I think at the end,they used IDE and with a scsi adpatorplate at the back

youre welcome. good luck gruss alan

I have repaird alot of these you open them,by banging a screwdriver along the line,allaround,then it opens. the problme is usually,that you have to resolder the plug.Also I used to glue the plug to the PCB. Sometimes it´s the trimmer which is bad,and I replace it. after repair,I just glue the two pieces together again. gruss Alan

great. have fun alan

Hello If you only use 1projector,make sure the short is made on the back on the "motorrelay"plug,for M1 otherwis it will not revert when no SRD alan